You can download the manual in PDF format by clicking here: quick-installation-guide.pdf  71.34 Kb

Alternatively you can use the quick installation guide.

Quick Installation Guide

In the package, you will find :

• a flow distributor (photo 4)
• a thick rubber hose 0,4m (photo 9)
• an o-ring (photo 3)
• a rubber washer (photo 6)
• a  bronze contraction (photo 5)
• and 2 spring clamps (a) and (b) (photo 11)

(A) Unscrew the tap spout grate (1).

For a male tap winding:

(B) If there is a male thread at the end of the tap's nozzle, use it to screw the flow regulator at the side with the concentric holes (2) after you place the o-ring (3) in between.

(C) At the other side of the flow regulator (4) screw the bronze contraction (5) placing the rubber washer in between (6).

(D) Screw the tap spout grate (1) back using its own rubber washer. Proceed to step F.

For a feminine tap winding:

(E) If the screw thread at the end of the tap's nozzle is female reverse the order of the steps screwing the brass contraction first and then the flow regulator. First put the brass contraction (5), then the rubber washer and then the flow regulator (4).

Next Step:

(F) Attach the (7) thick rubber hose to the (4) flow regulator using (11b) spring clamp (12). Use pliers.

Attach the other end of the thick hose to point (8) of the filter using spring clamp (11a) and cut off the piece of hose you do not need.

(G) Attach the thin hose (9) to point (10) of the filter, in order to drain the water from the filter into the sink.

(H) Plug the device to the mains. Turn on the tap and let enough water run until it gets rid of the powder of active carbon and the water is clear.

(I) Put the tap spout grate back with its own rubber washer.